Exciting times ahead!
We know you can’t wait to start strolling; watch our simple step-by-step instruction video and you’ll be on your way in no time!
If you have any questions, you can get in touch with our friendly team here.
1. Assemble the cross-brace for underneath the seat
1a. Slot the cross-brace bars (C) together using the notches in the centre of each piece.
1. Assemble the cross-brace for underneath the seat
1b. Secure pieces together in the centre hole by using screw (S2) and the small allen key (N) ensuring you put the screw in from underneath as below.
2. Install the high chair legs
2a. Before continuing, flip the crossbrace back the right way so that the screw is facing the ground.
The legs with the holes in the side are the front legs - this is where the footrest will attach. These must be next to each other.
2. Install the High Chair Legs
2b. Before proceeding with attaching the legs, ensure the bolt nuts (K) are in the correct starting position as below.
The hole in the side of the bolt nut (K) needs to be facing towards the screw hole so the screw can go through it.
2. Install the High Chair Legs
2c. Align the top of each leg (D) with one end of the wooden cross brace (C) put together in Step 1.
2. Install the High Chair Legs
2d. Using a flat head screwdriver, insert the bolt nut (K) into the bolt nut hole in the side of the leg. Insert the connecting leg screws (S4) into the screw hole and tighten using the small allen key (N). Only loosely tighten the bolts in the front legs.
Screw the four black feet stoppers (L) into the bottom of each leg.
3. Installing the footrest
3a. Line up the footrest (F) with the smaller holes in the sides of the front legs.
3. Installing the footrest
3b. Attach using screws (S2) through
the holes in the back of the front legs
and the small allen key (N). Once the
footrest is secure, you can fully
tighten the screws in the front legs.
4. Attaching the seat
4a. Fix the seat (A) to the base by aligning the holes in the underside of the seat with the holes in the top of the cross brace.
4. Attaching the seat
4b. Turn the seat and legs on their side and secure them using the seat screws (S3) and the big allen key (M).
5. Installing the crossbar support
5. Align the holes in the back legs with the holes in the plastic support bar (G) and secure with the smallest screws (S2) and the small allen key (N).
6. Installing the tray
6a. To install the tray on the high chair, pull the release lever that is located underneath the front of the tray and slide it into the grooves in the arms of the high chair.
6. Installing the tray
6b. The tray can be adjusted to two-positions simply by pulling the release lever and sliding the tray to the desired position, hearing it click into place on the armrests.
7. Adjusting the top tray
7a. To remove the top tray, simply lift and pull the flap on either side of the top tray whilst holding down the bottom tray. It should unclip and easily lift off the base tray.
7. Adjusting the top tray
7b. To attach the top tray back onto the base tray, simply align the holes in either side of the top tray with the plastic circles on the side of the base tray and push down until you hear a ‘click’.